Dynon 180 hobbs problem

[nice1111]

Hi All and Dynon support.

I have d180, which is great btw. my problem is that when i got my ctsw, the 180 was set to other setting and not Rotax, as i have 912 rotax engine.

I have now switch to the rotax setting which now only records hobbs time. I have up until now been recording tach and hobbs and i use the tach time as my flying time.

Early on when i got my ctsw i left the master switch on for about 40hrs :-[ and the hobbs now reads 176.2 hrs and my tach reads 132.6 hrs.

So, what i want to know is, can i reset the hobbs time to read 132.6 hrs or can i reset it to zero??? Obivously, this will be recorded in my logbooks

There, i finally go it out

So any help would be great appreciated

Thanks neil

 

[PhantomPholly]

Download the PDF install manual and just search for "Hobbs."  It will take you right to what you need:

If you need to adjust the Hobbs time on the FlightDEK-D180 to match that of your engine, press
DOWN[ch9660] to select the item, SET HOBBS TIME. Press SEL[ch9658] to enter the Hobbs time setting
submenu. Press SEL[ch9658] to select the desired digit and then DOWN[ch9660] or UP[ch9650] to change the
value. When you are finished, press BACK.
If you need to adjust the tachometer time on the FlightDEK-D180 to match that of your engine,
press DOWN[ch9660] to select the item, SET TACH TIME. Press SEL[ch9658] to enter the tachometer time
setting submenu. Press SEL[ch9658] to select the desired digit and then DOWN[ch9660] or UP[ch9650] to change
the value. When you are finished, press BACK.

 

[nice1111]

Thanks for the help!!

you thought i might have checked that. :-[ :-[

Oh well i'd rather ask anyway ;D

thanks again

neil