Dynon autopilot and garmin-695

[igor113]

Hi! I have skyview and garmin-695 attached to it. Tell me please, why i can't see mode nav for horizontal autopilot and how to achieve that autopilot work with flight plan in garmin-695 ?

 

[dynonsupport]

A few things to check (refer to the installation guide for details):

Have you confirmed that the serial port that you've physically connected the 695 to is the one that you've configured SkyView to receive serial information from under SETUP > LOCAL DISPLAY SETUP > SERIAL PORT SETUP ?

Under that serial port setup, is the rx counter increasing? If not, SkyView isn't seeing ANYTHING on that serial port, either because the 695 isn't physically connected, or it's not set to output data.

Is the 695 configured to output NMEA data? What NMEA output settings do you have configured for the 695?

 

[igor113]

It is set of garmin-695 in dynon

 

[igor113]

but i have this:

 

[igor113]

and Dynon can't see satellite

 

[igor113]

may be i must select gps in this menu?

 

[igor113]

I have map license

 

[igor113]

this is setting in garmin-695

 

[igor113]

this is setting dynon gps

 

[igor113]

when dynon gps work

 

[igor113]

and one more question: after upgrade system^i can't see tas!!! why?

 

[dynonsupport]

The plain "NMEA" mode is actually only 4800 baud output. Change that to the NMEA+VHF output, and make sure the other option is "normal", not "fast" (not sure what it's saying in your language, sorry)

 

[igor113]

thank you very much!!! all work!!!