valerieflyer
I love flying!
I just completed hookup of the garmin 155xl via arinc429. It had been working perfectly when connected via nmea serial. Now, I purchased an HS34 and want to use the arinc429 connections. The gps acquires position but the hsi still says waiting for gps pos. No course guidance is displayed. It acts like it is not communicating. I have arinc429 turn on in the garmin and have tried "selected course" and "course, heading" settings for the arinc output.
I have gone into the master efis, hsi menu and selected arinc429, low speed for input and output.
these are the connections I used:
pin 11 (hs34 female) to pin 15 garmin 155 (arinc429_outB)
pin 13 (hs34 female) to pin 33 garmin 155(arinc429_inB)
pin 23 (hs34 female) to pin 16 garmin 155(arinc429_outA)
pin 25 (hs34 female) to pin 32 garmin 155(arinc429_inA)
should this setup work? Is there something I missed? All other functions of the hs34 are working and it is configured on the DSAB bus.
thanks,
Valerie
I have gone into the master efis, hsi menu and selected arinc429, low speed for input and output.
these are the connections I used:
pin 11 (hs34 female) to pin 15 garmin 155 (arinc429_outB)
pin 13 (hs34 female) to pin 33 garmin 155(arinc429_inB)
pin 23 (hs34 female) to pin 16 garmin 155(arinc429_outA)
pin 25 (hs34 female) to pin 32 garmin 155(arinc429_inA)
should this setup work? Is there something I missed? All other functions of the hs34 are working and it is configured on the DSAB bus.
thanks,
Valerie