Dynon D6: Alt. Encoder cable shield gnd where?

hplevyak

I love flying!
Joined
Aug 19, 2013
Messages
6
Folks,
The D6 Altitude cable (bundled 2-wire) is a shielded cable. Page 2-2 Schematic shows the shield going to ground.

What side of the cable should be used for shield to ground. The D6 EFIS side....or should I ground the shield at the Transponder side?

Thanks,
Howard
 

hplevyak

I love flying!
Joined
Aug 19, 2013
Messages
6
I just found an old instruction sheet. It says "DO NOT" ground the transponder side of the shield. This is done on the main connector side.

So I'm just heat shrink sealing the xpndr side of the shield closed.

Howard
 
Top