Janekom
I love flying!
I am trying to figure out how to solve this problem. Not my RV10 but I would like to solve the problem for him. Is seems that the AP will disconnect randomly on most flights. Sometimes without warning and sometimes after a few slip warnings. He has a SV42 as roll servo and a SV42 with torque enhancer arm as pitch servo.
I cannot find any physical installation problems at the servos. We have searched this forum for "standard" setup parameters and have set the AP up that way.
So where do I start? I suspect wiring issues. Can someone in the know tell me what the most probable cause for this is and where to start looking?
Settings from memory:
Roll
Torque 70%
Sensitivity 10.0
Roll Gain 0.4 Def is 0.0
Bank Angle Limit 30 degrees
Pitch
Torque 70%
Sensitivity 10.0
Pitch Gain 2.0
Altitude Gain 0.6
Pull Rate 1.0
VSI Gain 0.6
G Error Gain 1.0
G Error Limit 0.25
Def Climb Vert Spd 500 FPM
Def Descent Vertical Spd 500 FPM
Max Airspeed 180 Kt
Min Airspeed 90 Kts
I cannot find any physical installation problems at the servos. We have searched this forum for "standard" setup parameters and have set the AP up that way.
So where do I start? I suspect wiring issues. Can someone in the know tell me what the most probable cause for this is and where to start looking?
Settings from memory:
Roll
Torque 70%
Sensitivity 10.0
Roll Gain 0.4 Def is 0.0
Bank Angle Limit 30 degrees
Pitch
Torque 70%
Sensitivity 10.0
Pitch Gain 2.0
Altitude Gain 0.6
Pull Rate 1.0
VSI Gain 0.6
G Error Gain 1.0
G Error Limit 0.25
Def Climb Vert Spd 500 FPM
Def Descent Vertical Spd 500 FPM
Max Airspeed 180 Kt
Min Airspeed 90 Kts