billpilot1
New Member
- Joined
- Nov 5, 2008
- Messages
- 4
Hell-o Bill here. I'm looking for a way that I can check to see if I have my EDC-D10A wired up correctly. It is not recognized by my EFIS yet. I thinking that I might have switched the wires on the DB9 pin. Is there a voltage test or resistance test I could do on the plug when I pull if off the EDC-D10A. IN reading some of the post, It mentions wireing it to the OAT probe... I think I only have the 2 wire probe. I'm having a real problem with my auto pilot so I'm trying to re-calabrate everything from the start and see if I can't catch it.... But the remote compus isn't working yet, so One thing at a time!
How will I know if you answer me here. This site has become very large and don't know if I will find the answer?
Thanks...
Bill
How will I know if you answer me here. This site has become very large and don't know if I will find the answer?
Thanks...
Bill