I updated my EFIS-D10A to 5.5 firmware this morning...it's wired to an EDC-D10A which works properly. EFIS heading wanders when a magnet is moved around the EDC and the EFIS OAT responds when the EDC OAT probe is warmed. When I used the support utility to detect the firmware (5.4) I got an "EDC not detected" warning but the utility correctly read the EFIS firmware and serial number. I went ahead with the upload thinking it might be an EDC firmware mismatch - the EFIS firmware updated as expected but I still get an "EDC not detected" message. Anyone got any ideas on how to resolve this?
OBTW, my DSAB bus is (still) non-functional, the EFIS can't see my EMS-10A with any number of different wiring harnesses, could this be related? I was hoping maybe a firmware mismatch EFIS-to-EDC was causing it but I can't tell.
Thanks in advance,
Nauga
OBTW, my DSAB bus is (still) non-functional, the EFIS can't see my EMS-10A with any number of different wiring harnesses, could this be related? I was hoping maybe a firmware mismatch EFIS-to-EDC was causing it but I can't tell.
Thanks in advance,
Nauga