I cannot find the pin assignments for the EGT and CHT probes. The diagram on page 2-6 of the EMS-D120 installation guide does not show which pins go to which cylinders. I could assume the the top most probes in the diagram go to cylinder #1 but "assume" could mean something else in this case. I did find a post (http://dynonavionics.com/cgi-bin/yabb2/YaBB.pl?num=1172509605) that asked this same question, but the link is dead and used to go to the installation guide, I think. Please help.
thanks!
Pat
thanks!
Pat