EMS D10 Altitude Data

[aeroads]

How can I feed altitude to my EMS D10 to have it calculate % max eng HP? I have a G396 and a EFIS D10 Many thanks Murray Randall aeroads@comcast.net

 

[dynonsupport]

Page 4-2 of the EMD-D10 install manual covers this:

http://dynonavionics.com/downloads/Install_Guides/EMS-D10 Installation Guide.pdf

Note that we only support % power on lycoming/continental engines, and you must have OAT and fuel flow installed.

 

[aeroads]

I have read and reread 4-2 and I believe I should connect the "Blue" wire from the G396 to pin 12 on my EMS Is that correct? Many thanks Murray

 

[aeroads]

Can I connect my EFIS D10 to my EMS D10 for the % HP altitude reqts I am presently connecting the G396 BLUE wire to a TruTrack A/P Can I feed the G396 blue wire to both the EMS and the TruTrack? Many thanks Murray

 

[dynonsupport]

You can share the blue wire between the TruTrak and the Dynon EMS-D10 without any problems.