EMS FAIL

[jonjonjon4]

I have just reinstalled my SV EMS-220 after a repair by Dynon. Power up and the EMS FAIL panel with the cross comes up! Can anyone help me with my next move? Is there some reconfig process that has to be done. The Warning Panel say there is a Software Mismatch but I am unsure what that means in reality.
I have tried to reload the software but SV rejects that move saying my 7.0 is older. Would that mean there is a later full software version that needs uploading that Dynon may have loaded on the EMS when they had it?

 

[dynonsupport]

You need to do a network configuration in the setup menu.

 

[sangliervolant]

I have the problem too.
I do the network configuration, and the SV EMS is find in the network status with the 2 displays screens.
GPS give me the position.
But SV EMS give a EMS FAIL on the 2 displays.
Except anmeter, no sensor connected.
Settings file OK for engine IO360.
Could you help me please ? 

 

[Dynon]

Can you email pictures of what you are seeing to support at dynonavionics dot com?

 

[dabear]

Are you running the latest version of software? If you are back a couple of revisions, the replaced EMS may be at a new version.

Try rebooting all your screens with all modules powered. It should find it an update the EMS. You can force the EMS to update.

 

[sangliervolant]

yes i upgrade softwares.
i reboot all more and more...
How to force EMS update ? Where can i find the ems software ?
pictures are on the website:
http://sangliervolant.net/articles/view.php?id=190&action=dynon-skyview-ems-fail

 

[Dynon]

That's stumping me at the outset, admittedly. Go to SETUP MENU > SYSTEM SETUP > NETWORK SETUP > FORCE NETWORK LOAD to reload the software on the EMS module. By the way, is your second display powered off in that picture (it's showing offline)?