EMS-FlightDEK-D180

[elsen]

Hello,

Can you tell me which value I have to choose by "PULSES/REV" when I use the Rotax 912S.

FlightDEK-D180, S/N 001142

Best regards,

André van den Elsen
The Netherlands

 

[dynonsupport]

It appears nobody here knows that off the top of their heads. There's no harm in setting the wrong number here, and it's generally pretty obvious when you get it wrong. If it's reading high, increase the number, if it's low, decrease the number.

 

[Simn_Smith]

I have a 914 and can get a definitive answer on Monday but I know that when I first fired up the engine with the Dynon it was only reading half the revs (ie Engine 2500rpm, D180 said 1250rpm). If you know what the factory default setting is then this should give you a clue as to the actual setting required !