GigG
New Member
I purchased all my wiring harnesses from Dynon. I seem to have found some points where the wires aren't in the right spot. Well, at least with the installation manual I have which is Revsion D dated Oct 1, 2007.
Here's is what I;ve found so far. All the problems seem to be on the D-25 connector.
17 is connected to the yellow w/green wire. The manual says 17 shouldn't even have a wire.
21 is connected to the Green that should be at 18.
18 is connected to the White that should be at 21.
Ideas? Have you changed the pinouts on the 180?
Here's is what I;ve found so far. All the problems seem to be on the D-25 connector.
17 is connected to the yellow w/green wire. The manual says 17 shouldn't even have a wire.
21 is connected to the Green that should be at 18.
18 is connected to the White that should be at 21.
Ideas? Have you changed the pinouts on the 180?