Fuel

[karmarepair]

1. Is there some way to kill the fuel computer? I don't have a fuel flow transducer, but I keep getting notifications of a mis-match between computed and measured fuel levels.

2. When calibrating with a capacitance probe, and you finish physically making the last "Pour", do you pres "Add" and then "Full" or just "Full"?

3. How do you see the calibration values past about the seventh entry once the screen fills up? There is a little down arrow, but how do you scroll through that screen?

This is on a SkyView SV-D700, running firmware 16.0.1.7770

 

[skysailor]

1- You can turn that off in Settings. The item is labeled "Detect fuel added" I believe.

2- You only press Full.

3- I think the right knob becomes a scroll in that window when it is displayed.

 

[karmarepair]

1. Thnx!
2. Ah, No. You press "Full" and you're done, WITHOUT saving your last Pour.
3. I haven't been able to make mine do that during the calibration routine.

ALSO, my SkyView TELLS me how big to make the Pours, which is NOT what my manual said. Example, I told it the tank was 16 gallons full, it asked for 2 gallons pours. When I told it 15, it asked for 1 gallon pours.