I am installing two Dynon 700 units which are inter-connected and sharing configurations. I have attached the Dynon GPS unit but information from it appears on only one screen. I cannot get the data from the GPS to replicate on both screens. They have been installed in accordance with the latest installation manual (Revision G) and I have installed Firmware version 3-0-0. Any ideas please? Many thanks in anticipation.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
GPS to multiple screens
- Thread starter DGSC
- Start date
- Joined
- Mar 23, 2005
- Messages
- 13,226
The GPS needs to be connected to a serial port on EACH display, and each of the serial ports that the GPS is connected to on each display needs to be configured to to receive SV-GPS-250 data.
In other words, this information isn't shared over the SkyView Network.
In other words, this information isn't shared over the SkyView Network.
- Joined
- Mar 23, 2005
- Messages
- 13,226
What about the other half - setting up the serial port setting on both displays independently? Have you confirmed that? If so, give us a call and we can help you troubleshoot further.