Kavlico fuel pressure sender

[davejohnson]

I am installing a ULPower 350Is (injected) and have the Kavilco fuel and oil pressure senders. When I run the electric pump (either of them) I get a pressure reading of 11psi, it should be around 35psi. My first thought was that I had swapped the oil(150psi) sender with the fuel(50psi), but have checked them and they are the right way around. Any suggestions as to what is wrong?

 

[dynonsupport]

Dave:

Which of our EMS systems do you have?

Did you configure the EMS to specify that you have the correct sensor type?

I am installing a ULPower 350Is (injected) and have the Kavilco fuel and oil pressure senders. When I run the electric pump (either of them) I get a pressure reading of 11psi, it should be around 35psi. My first thought was that I had swapped the oil(150psi) sender with the fuel(50psi), but have checked them and they are the right way around. Any suggestions as to what is wrong?

 

[BlueCH750]

Dave,

Did you ever figure out your issue? I'm starting my sensor installs and wiring now on my UL350iS...Thanks!