Flying yesterday I had the HSI and selected to Skyview and put in a direct to destination. The HSI responded normally, the map failed to display the course line. Switching to the 430 as the source the course line shows up. I then selected different destinations on both the Skyview and 430. Switching between the 430 and Skyview changed the HSI as expected but the direct to course on the map was that of the 430 and did not change. I then powered off the 430 and the course was still displayed.
I have V 10.0 installed and it seemed to work properly on a previous flight. The only change was time as the map database expired and I got tired of waiting for the download so I flew without updating.
Any ideas? Could this be a 10.0 bug? I will load 10.1 and an updated database for the next flight.
Ralph
I have V 10.0 installed and it seemed to work properly on a previous flight. The only change was time as the map database expired and I got tired of waiting for the download so I flew without updating.
Any ideas? Could this be a 10.0 bug? I will load 10.1 and an updated database for the next flight.
Ralph