Network detection of servos

Dynon

Dynon Staff
Staff member
Joined
Jan 14, 2013
Messages
14,232
Location
Woodinville, WA
If you bought the servos this year, unless they came from some VERY old stock from a dealer that has had them on hand for quite a few years, it's not the case of "old" servos. What are there serial numbers?

I think you've done the troubleshooting I'd have you do - get it down to the display, ADAHRS, and one servo (with that servo powered up, of course). What do you see when you do a network configuration in that state? Nothing at all for the servos? Or is the servo visible but with an error message?
 

Dynon

Dynon Staff
Staff member
Joined
Jan 14, 2013
Messages
14,232
Location
Woodinville, WA
All of that said, if you're not seeing anything on the network configuration page, we'll probably need to see the servos here to reprogram them.
 

RGraham

I love flying!
Joined
Dec 6, 2014
Messages
3
Yes, confirmed 11.6V @ servo before network detection attempt. Tried 1 servo at a time hooked right to the back of the Skyview with the ADHRS only , and also without any other module attached. Made a short 2' harness to test with after removing servos - no joy.

The confusing part is that I had roll (SV42) working if pitch (SV32)was not attached up until I installed 11.1 pkg. update, and from that point forward I could no longer network detect the roll.

Confirmed Pin1-Green, Pin6-Blue, Pin-4 Wht/Blu, Pin8-Wht/Grn

SV32 S/N-8216
SV42 S/N-6493

Servos now returned to Dynon
 

Dynon

Dynon Staff
Staff member
Joined
Jan 14, 2013
Messages
14,232
Location
Woodinville, WA
I can't tell immediately from our logs here, but did you get an RMA from our support team? If not, can you get in touch with them at support at dynonavionics dot com or 425-402-0433. Ideally we like to have the RMA on the inbound box, else it can take some extra time to get it sorted out when it gets here.
 
Top