New install HDX, AP servos not found.

[britguy59]

Replaced D100 with HDX, uses same servos. Servos working fine before. Checked Power, grounds, data pins correct, going to Serial input on Screen rear, and one going to serial Multiplier (dynons) with other devices. Network check does not find them, no evidence or any connection. All required connections seem complete per wiring diagrams.

Suggestions?

 

[jakej]

Are you seeing anything on the network .?
If not, then please get help from someone close who owns or understands the Dynon system before a mistake becomes expensive - for your sanity .
PM me if you want.

 

[jakej]

Britguy - did you update the servos/D100 system with software version 5.6.1 anytime before changing over to HDX ?
If no, then the HDX system will never ‘see’ the servos until that’s done. Do you still have the D100?

 

[airguy]

You will likely need to recalibrate the servos after doing a "network find"