No ADSB data on display #2

[GalinHdz]

During today's flight I noticed that there was no ADSB data on the co-pilot display. Nothing (traffic nor weather) was showing up on the co-pilot side display MAP or PFD page while the pilot side display had everything. Both displays are connected to the DYNON network and to each other via the ETHERNET cable. Is there someplace I have to set up so it shows correctly or does it only show on one display? This is a fairly new install and I had not noticed this before so I am not sure if it has always been this way. :-/

 

[dabear]

Serial connection from both displays to the ADSB module?

 

[GalinHdz]

Serial connection from both displays to the ADSB module?

Yes, both are connected in parallel. :-/

 

[GalinHdz]

Now, display #2 (the one not showing ADSB data) just came back from DYNON after being repaired for the circuit board problem. I wonder if this has anything to do with it?  :-/

 

[dabear]

Double check configuration on display #2 and that it has the right serial connection, serial config (Dynon ADSB).

 

[GalinHdz]

Double check configuration on display #2 and that it has the right serial connection, serial config (Dynon ADSB).

Did it today. Display 2 shows DYNON ADSB on serial port 3 and it even shows that data is being received on the line. :-/

 

[dynonsupport]

Did you have the screen set to display weather? The display of weather (Terrain, Terrain + WX, WX) is a per-screen setting.

What did it show in the corner for traffic status? ADS-B FULL, PARTIAL, or FAIL? If there was no indicator there, then maybe you have traffic turned off for that screen as well (Setup->Traffic)

 

[GalinHdz]

Did you have the screen set to display weather? The display of weather (Terrain, Terrain + WX, WX) is a per-screen setting.

What did it show in the corner for traffic status? ADS-B FULL, PARTIAL, or FAIL? If there was no indicator there, then maybe you have traffic turned off for that screen as well (Setup->Traffic)

OK, I will check this next time I get to the hangar, probably on Saturday.

 

[GalinHdz]

Did you have the screen set to display weather? The display of weather (Terrain, Terrain + WX, WX) is a per-screen setting.

What did it show in the corner for traffic status? ADS-B FULL, PARTIAL, or FAIL? If there was no indicator there, then maybe you have traffic turned off for that screen as well (Setup->Traffic)

I ran out to the hangar and it was exactly as you said. I had the traffic off on Display #2. I turned it on and everything worked. THANKS!