No "AMP" listed in FUNCTION list

[AssoX]

I have wiring a GRT CS-01 AMP sensor on pin 22, 18(+5V) and 30(Ground).

But when I want to configure it, in EMS SETUP>SENSOR INPUT MAPPING, I choose Pin 22, the "AMP" is not listed in the "FUNCTION" list..

Why ?

I am using The Skyview 3.3.2 firmware and sensor_03_21_2011.sfg file

 

[dynonsupport]

I have wiring a GRT CS-01 AMP sensor on pin 22, 18(+5V) and 30(Ground).

But when I want to configure it, in EMS SETUP>SENSOR INPUT MAPPING, I choose Pin 22, the "AMP" is not listed in the "FUNCTION" list..

Why ?

I am using The Skyview 3.3.2 firmware and sensor_03_21_2011.sfg file

Support for the GRT CS-01 was added in a later EMS Sensor Definitions File than the one currently on your system. Download the latest version here. Right-click to save that file, put it onto a USB Flash Drive, then take it to your SkyView and load it (on ALL displays if you have more than one).