No Carb Temp

snowyriver

Member
Joined
Jan 1, 2010
Messages
48
During my install I connected the carb temp sensor. If I'm not seeing it in my EMS display does that mean I have a problem with my wiring? I used the standard Lyc sensor profile and all of the other things (oil temp, press, cht, etc) were there automatically. Thanks Craig
 

dynonsupport

Dynon Technical Support
Staff member
Joined
Mar 23, 2005
Messages
13,226
There's a separate carb settings file (that's different from the fuel injected version) for both 4 and 6 cyclinder Lycomings that you can get here. Do you have that loaded? If not, start there first.
 

snowyriver

Member
Joined
Jan 1, 2010
Messages
48
I loaded the Lyc carbureted eng file approx a yr ago. It's a newer revision. I'll try that newer one first. Thank you.
 

B4-METRIC

New Member
Joined
Jun 26, 2011
Messages
4
I also installed a carb temp sensor and can't find where to read it.
What download files about Lycoming are we referrring to. Is this something I missed in the directions.
Would appreciate some help here.

Al
 

dynonsupport

Dynon Technical Support
Staff member
Joined
Mar 23, 2005
Messages
13,226
See the post two above, along with the link. There are two ways you can get carb temp to show up:

You can add it to your pin layout in the EMS SETUP menu, then add it to your 100% and/or 50% and/or 20% Engine page layouts.

Or, if you've followed the pinouts shown in the manual go here:

http://dynonavionics.com/cgi-bin/yabb2/YaBB.pl?num=1262907450

...and follow the instructions, downloading the file that is appropriate for your engine.
 
Top