My D-100 has worked flawlessly for almost 3 years but when flying back from Oshkosh the display started to show horizontal noise like patterns reminiscent of raster scan lines. The lines also appeared related to the display driver as they appeared to map to each screen in split screen mode. I though maybe it was hot so put some cover on the dash and the problem finally went away. This morning I flew and the problem appeared again for the entire flight. Tried in the hangar without the engine running and the problem comes and goes.
From a system standpoint nothing has been changed recently and I tried it with other systems on and off (D120, SL30, GTX 327, ADI II, 496) with no change in behavior. Any ideas or is this something that requires a return to Dynon
Thanks
From a system standpoint nothing has been changed recently and I tried it with other systems on and off (D120, SL30, GTX 327, ADI II, 496) with no change in behavior. Any ideas or is this something that requires a return to Dynon
Thanks