Non-dynon oil temp sender

[n28et]

Hello,

I am converting from a Rocky Mountain uMonitor which uses an AD590 temp transducer for oil temperature.  It has a linear current output of 1 [ch956]A/K (microamps per deg. Kelvin).  Is there anyway to configure this transducer with the Dynon EMS?  I was thinking possibly using pin 6?  Any help is appreciated.

Thank you.
Erich

 

[Dynon]

On a D10/D120/D180, it's not possible. With SkyView it technically possible, but it's far from trivial. It's usually much easier to switch to one of our oil temperature sensors.

 

[n28et]

Hi Dynon,

Thank you for the quick response. While I have a Skyview, I don't need to take on a non-trivial task. I will go ahead and order a new temp sensor.

Erich