I am getting normal EGT readings, but the reading is getting a Yellow caution indicator. I've been told to recheck the temperature settings that should receive a Yellow or Redline flag. I've searched the Pilot's User Guide for both the D10 and D100, as well as the Installation Guides for instructions on where and how to do this, but can't find a procedure. Can someone point me in the right direction to find instructions?
You're looking for EMS>MENU>SENSORS>EGT, and then adjust the different red/yellow/green borders.
DBRV10
Active Member
And just for the record, except for TIT, there are no red lines for EGT. They do not exist, despite what some people will say.
Set 0-1550 as green and 1550-1700 as yellow. That way if you have a faulty plug or lead the EGT will rise up and give you an alert.
Set 0-1550 as green and 1550-1700 as yellow. That way if you have a faulty plug or lead the EGT will rise up and give you an alert.