I am installing complete Skyview HDX suite with EMS.
My plane, ( a Berkut with a Lycoming O-360), had a VM1000 EMS from Vision Microsystems inc. It used Pressure transducers from the same company for both oil pressure and fuel pressure (shown below) the VM part number was (is) 3
It has 4 wires coming out the back, labeled 1-4 while the photos of the Kavlico and Dynon pressure transducers in the installation manual only have 3, (power, ground and sensor output).
Is this transducer compatible with the Skyview EMS?
If so, does anyone know wich of the four leads goes with the three jnputs required by the SKyview EMS? ( 5V power, ground & sensor output)?
Thanks!
My plane, ( a Berkut with a Lycoming O-360), had a VM1000 EMS from Vision Microsystems inc. It used Pressure transducers from the same company for both oil pressure and fuel pressure (shown below) the VM part number was (is) 3
It has 4 wires coming out the back, labeled 1-4 while the photos of the Kavlico and Dynon pressure transducers in the installation manual only have 3, (power, ground and sensor output).
Is this transducer compatible with the Skyview EMS?
If so, does anyone know wich of the four leads goes with the three jnputs required by the SKyview EMS? ( 5V power, ground & sensor output)?
Thanks!
