Pin callouts for GTN650 ARINC429 and Intercom 2S

[compnz]

Is there a list of pins or drawing available detailing the install of a GTN650 to the Dynon Skyview system - using the Intercom 2S and the ARINC429 and using the SV-COM-C25 as COM1.
Apart from what is in the SV install manual.

 

[jakej]

Arinc 429 is as per the SV install manual, no other wiring info needed for that.
Garmin GTN 650 as # 2 Com ---

Connector P1003 Dynon Intercom
Phone Audio HI pin 7 pin 8
Lo pin 18 *
Mic Audio HI pin 5 15
LO pin 20 *
Mic KEY (TX) pin 11 12 (switch)

refer to the note about the asterix (*) in the Intercom install manual.

HTH or PM me & I'll call you if you wish.

Jake J

 

[compnz]

Jake, thank you, just what I was after. Any comments on running it as COM2?

 

[jakej]

You can make it either one, up to you. However if you have the Dynon as (displayed on SV) Com 1 you can use the database for entry of Com frequencies, that requires a current database but a lot don't do that here due cost.

Jake J

 

[dynonsupport]

Fair point - the GTN 650 is one of those units that there is a significant installed base for, so we'll update the COM radio and serial connections sections for the GTN 650 in a future update of the SkyView System Installation Guide.

Is there a list of pins or drawing available detailing the install of a GTN650 to the Dynon Skyview system - using the Intercom 2S and the ARINC429 and using the SV-COM-C25 as COM1.
Apart from what is in the SV install manual.

 

[compnz]

Great thanks, look forward to the update