I am installing a dual Skyview in an RV 10. I am trying to determine if I' m having a problem or not.
I am getting both a pitch error and a roll error indication. Both just seem to wander around not locking on to any point. Pitch wanders around 15 degrees and roll stays level but heading wanders 10-20 degrees.
I am running 3.2.2 firmware and all devices are detected. I have calibrated the A/P servos and the trim indicator. I have not calibrated the compass yet or the AOA since the airplane is still in the hanger. Is this simply a calibration issue or is it something else?
My installation has dual AHRS mounted in the top of the 10 tail cone above the battery and pitch servo. There is at least a 2.5 foot separation between the battery and the servo. There are no antenae closer than 5 feet away. I used all brass hardware. Pitch and roll are less than .5 degrees off center.
Any advice would be appreciated. Greg
I am getting both a pitch error and a roll error indication. Both just seem to wander around not locking on to any point. Pitch wanders around 15 degrees and roll stays level but heading wanders 10-20 degrees.
I am running 3.2.2 firmware and all devices are detected. I have calibrated the A/P servos and the trim indicator. I have not calibrated the compass yet or the AOA since the airplane is still in the hanger. Is this simply a calibration issue or is it something else?
My installation has dual AHRS mounted in the top of the 10 tail cone above the battery and pitch servo. There is at least a 2.5 foot separation between the battery and the servo. There are no antenae closer than 5 feet away. I used all brass hardware. Pitch and roll are less than .5 degrees off center.
Any advice would be appreciated. Greg