Pulse oximeter / CO detector display

[RockFLY]

Hi Guys,

Do you intend to display the CO Guardian Oximeter and/or CO PPM readouts via Skyview at some stage in future?

I see that AFS, GRT, AFS and EI are already doing this.

Cheers, Stu

 

[dynonsupport]

We were working with CO Gaurdian, but between the two companies we never completed it. There doesn't seem to have been much demand, but we will start the communication again to see if we can add that support. So no promises, but we'll see what we can do.

-Dynon Support.

 

[N714b]

I'm sure Ash would love to get on board. They output their message via RS 232 so it's just another serial port we'd have to use

 

[dynonsupport]

At this point we don't really have the customer interest to spend the time doing a whole serial implementation (plus everyone will yell at us for not having enough serial ports even though we have WAY more usable serial ports than anyone else in this market).

We have a way to interface with it using the analog EMS inputs, since the devices output a voltage vs PPM. We discussed this with Ash but for some reason it never really got anywhere. If people are really out there and want this connectivity, we can discuss how to do it.

 

[mmarien]

It's not a question of not enough serial ports, it's that the Skyview is way too versatile. Poll on the number of serial port used is here.

http://dynonavionics.com/cgi-bin/yabb2/YaBB.pl?num=1338252641

 

[GalinHdz]

But can you connect the CO Guardian remote alert relay (pin 4 or 6) to the Skyview EMS as a general purpose contact and have it display as an alert?