Put on 4.2 and now 100 does not recognize 180

[SHORTRV7]

Ok, I upgraded my D-100 and D180 to 4.2. Now the D100 does not recognize the D180. Whats do I do??? They sure worked fine with the 1.08 they came with. Also when I cycle through the screens (5 different ones) after the 5th on the D180 turns off and then comes back on?????
Don

 

[dynonsupport]

4.2 talks between the units in a different way than it used to. You need to go into the DSAB setup menu and configure your network.

Instructions on how to configure the network are on the page that lets you download 4.2 software:

http://dynonavionics.com/docs/support_software_200710.html

No idea why the D180 would reboot on the 5th page. What is the 5th page defined as in your screen setup list?

 

[SHORTRV7]

Dynon, I will have to call you tomorrow, the going off problem is worst. Now the unit will not come on, it tries to, then the screen flashes RED and goes off. I do understand about the DSAB setup but which one would one put the master on? I am still building on my RV-7 and have not flown with these units yet.
Don

 

[SHORTRV7]

Thank you Tech dept, we got it fixed and is now working again. I am trully impressed with you company.

don