Anybody have a picture of how the resistor is wired in-line to the P-lead? The instructions say to place it as close to the P-lead as possible, but those things are pretty fragile looking. How have others done it?
(if you have a pic of your installation, feel free to e-mail or post)
N8RV *at* gte.net
I think I figured out the source of my confusion, but would appreciate confirmation from someone with Dynon Support.
The original installation instructions I have did not have a drawing, and the narrative said to put the resistor as close as possible to the P-lead. That tells me that it should be AT THE MAG END of the wire, not back at the switch.
However, the current instructions have a drawing that shows the resistors at the SWITCH end, on the lead between the Dynon unit and the switch, NOT the line from the switch to the mag. Big difference.
Hope that's right ...
Thanks!