re-startup

[Rob]

Hi, I have just started up my skyview I do not have any EMS wires connected but every thing else is except the wing servo , I only get on the right side a map of USA and EMS fail also ADHARS fail there is a red light flashing on all modules can you advise what I can do ,I have not loaded any data yet.
Cheers Rob (Australia)

 

[KRviator]

By startup, Do you mean you have you done the network config to force it to locate new modules - or connected everything and powered on the display for the very first time?

 

[Rob]

I have powered up for the first time I know realize I have to configure all the modules so will do that tomorrow and see how I go.
Rob

 

[KRviator]

That'll sort you out, Rob.

When you run the network configuration test, you may find a notification that some firmware needs updating. It may pay to grab the latest versions of the required files on a USB stick before you head to the hangar to avoid a 3rd trip!

 

[Rob]

I did take the new updates with me and it all worked fine ,Where do you find a hex code for mode s transponder and I can not get the jeppeson maps to show up on the screen It says they are loaded but all I get USA
Cheers Rob

 

[KRviator]

The HEX Code will be provided by CASA on request, but you'll need to have a registered aircraft or at least a registration reservation first. Hit up aircraft.register@casa.gov.au if you've been assigned a registration.

I'll have to defer to Dynon about the maps, as I'm going to use PocketFMS eventually.

 

[Rob]

Maps and all are now working it took quiet awhile for the GPS to find itself here once that happened the maps were there, I have talked to CASA about the hex code so all under control .Many Thanks