RED "X"s ALL ADHARS/EMS/MAP 3 finger Reset Needed

skypilotusa

I love flying!
Joined
Mar 1, 2014
Messages
17
I am about 3 weeks away from getting my RV-7A inspected for flight.  I have (1) 10" Skyview, EMS, ADHARS, Xpndr.  They have been installed and tested for about a year now.  Just in the past 2 weeks during testing of the systems... I sometimes get 3 RED "X"s across all systems, ADHARS "X" / EMS "X", MAP "X" all at the same time.  I can do a 3 finger reset and may not see it again... Today during testing all systems I had to reset the skyview 3 times. 

Also, when I was in the setup menus the Skyview locked up and stopped responding to any input. Another 3 figure reset required.

Any Ideas?
 

Garrett

I love flying!
Joined
Jan 5, 2013
Messages
208
Location
Tampa Fl
Maybe it is a loose connection somewhere in the wiring. Does it happen when there is movement of the aircraft or can the system stay on when left alone? :-?
 

skypilotusa

I love flying!
Joined
Mar 1, 2014
Messages
17
Happens standing still in the hanger... The Skyview has "NOT" went offline with the engine running and aircraft moving, at least yet. I have 2 engine runs, run-in, and full static rpm checks. with about .8 hrs on the engine at this time. Everything else in the aircraft (Electrically) is rock solid. Running VP-X Pro, Planepower 60amp main, and Planepower 30amp Secondary ALTs... Dual EMag-P114.
 

crashley

New Member
Joined
Jul 4, 2010
Messages
14
I Also had 3 crosses appearing but only for a few seconds it was caused by a wire to the gps aerial rubbing on the choke cable and sometimes shorting to earth
 

Dynon

Dynon Staff
Staff member
Joined
Jan 14, 2013
Messages
14,232
Location
Woodinville, WA
Does it happen frequently enough that you might be able to get a video of it and mail it to us?
 

skypilotusa

I love flying!
Joined
Mar 1, 2014
Messages
17
Yes... I will see what I can capture. Boot is normal, everything seems to be working fine. Then "Splat" everything goes offline. I thought it may be a low battery, but I ruled that out the other day. Main Battery showing 12.5v. It seemed to start when I installed version 7 about 6 months ago... But that is just a guess... Since the plane was not being powered up much back then I forgot about it. But, in the last month with Engine Starts and system testing it is happening almost daily. Seems strange that ALL systems would go offline. anyway... I will see what I can capture.
 

skypilotusa

I love flying!
Joined
Mar 1, 2014
Messages
17
I was able to capture the failures in a video this morning... Where would you like me to sent it? The ADHARS/EMS indicated failure after the system was powered on for about 12 minutes...
 

Dynon

Dynon Staff
Staff member
Joined
Jan 14, 2013
Messages
14,232
Location
Woodinville, WA
support at dynonavionics dot com works well. Include a link to this thread too for context.
 
Top