Hi!
I would have thought this has been asked before, but I couldn't find an exact answer...
I am making a Skyview network harness that goes from the SV-MAG-236 to one of the autopilot servos, to a network hub. The Skyview network cable definition includes two sets of power/ground wires, and I'd like to know if I can leave one of these two pairs disconnected. My proposed wiring is something like the table below:
SV-MAG-236 Servo HUB Other
Data 1A -------- Data 1A ------- Data 1A
Data 1B -------- Data 1B ------- Data 1B
Data 2A -------- Data 2A ------- Data 2A
Data 2B -------- Data 2A ------- Data 2B
Power 1 ---------------------------- Power 1
Ground 1 ---------------------------- Ground 1
Power 2 (none)
Ground 2 (none)
EMS Aux Volt (none)
Servo Power ---------------> Switch
Servo Ground --------------> Bus
AP Disc ------------> Stick
Thanks!
Luis
I would have thought this has been asked before, but I couldn't find an exact answer...
I am making a Skyview network harness that goes from the SV-MAG-236 to one of the autopilot servos, to a network hub. The Skyview network cable definition includes two sets of power/ground wires, and I'd like to know if I can leave one of these two pairs disconnected. My proposed wiring is something like the table below:
SV-MAG-236 Servo HUB Other
Data 1A -------- Data 1A ------- Data 1A
Data 1B -------- Data 1B ------- Data 1B
Data 2A -------- Data 2A ------- Data 2A
Data 2B -------- Data 2A ------- Data 2B
Power 1 ---------------------------- Power 1
Ground 1 ---------------------------- Ground 1
Power 2 (none)
Ground 2 (none)
EMS Aux Volt (none)
Servo Power ---------------> Switch
Servo Ground --------------> Bus
AP Disc ------------> Stick
Thanks!
Luis