Can anyone advise if this sensor is compatible with the DEK-D180 and if so should it be wired in the same manner as Rotax oil pressure sensor 956413. The DEK-180 manual doesn't have any reference to this newer sensor.
I have a Flight Dek D180 in a new installation with a Rotax 912ULS. While hand cranking the engine before initial engine start I do not get a oil pressure reading. I do get oil pumping through the engine and collected .5 litre after approx 60 revolutions. I have 12V at the sensor and the harness was purchased from Aircraft Spruce. The D180 is setup for sensor type 4 (p/n956413) although I have the new pn456180. You say the two sensors are equivalent and should be connected to the D180 per the manual. I am using Flight DekD180 Installation Guide P/N 100600-000 Revision H from August 2010. Is this the correct manual to be using? I purchased the D180 fall of 2013. Any thoughts why I can't get a pressure reading? Thanks for your help.