Rotax Oil Temp Audio Alert

[jnmeade]

Just installed dual HDX replacing DT1000s.
I don't get an audio alert if oil temperature goes into the high red range. (I don't recall if I had audio alert on the DT1000 or not.)
I've looked in the HDX Users Guide and in Chapter 12 I believe I see that oil temperature audio alert is possible.
I looked in SkyView Installation Guide and can't find how to enable or verify that oil temperature audio alert is enabled.
Any help is appreciated.

 

[Akash408]

Go to
EMS setting >sensor setting> here is three option .OFF ,self clear ,latching,select one option

 

[Stevec]

All the setting that can be enabled are in the Audio setup menu. Check page 4.21 of the installation manual

 

[Akash408]

 

[jnmeade]

I have the audio setup correctly.

Rotax 912 Behavior
Setting ENGINE TYPE to ROTAX 912 pre-configures some engine settings for a Rotax 912 engine. SkyView will automatically configure and dynamically change the oil temperature and tachometer scales and alert thresholds in accordance with Rotax’s recommended ranges, described in detail below. When this mode is selected, EMS SETUP > SENSOR SETUP > OIL TEMPERATURE AND TACHOMETER settings are unavailable.