RPM ratio

[jlbpropilot]

Is there a way to adjust the pulses per revolution in the Skyview system if taking the Tach reading from the ignition switch? Also, if one screen and all modules are installed how do you add an additional screen? Is there on cable that would go between the two or would I need to purchase more items than simply another screen? Thanks

 

[dynonsupport]

Yes, there is a place to adjust PPR in SkyView (as well as D100/D10 products).

If you add a second screen, you need one more network cable between the screens. Nothing else.

 

[n223rv]

This weekend I wired up my tach inputs from the left mag and right Lightspeed ignition and I was looking for where we set the PPM. I could not find it in the install manual nor by flipping through screens on the Skyview. I'm sure it is documented somewhere, but I could not seem to find it. Can someone provide guidance? Thanks
-Mike

 

[dynonsupport]

This is set under EMS Setup -> Engine Information

Covered on page 6-10 of the install manual if you are looking for it.