Servos not installed

[ackselle]

I'm getting the message "servos not installed"...I've checked power and ground...good at both servos, I've checked wire continuity from the servos to the Advanced Quick Panel module... all good... Skyview still tells me "servos not installed". Help?

 

[Dynon]

Assuming you're just connecting to the servos for the first time with your new QuickPanel: now that you have the panel installed and connected to servos, you'll need to do a SkyView Network Configuration and go through the autopilot servo setup/calibration steps from the installation guide.

 

[ackselle]

Thank-you. Absolutely correct. I did a SV Network Config, SV found the SV32s, they needed new firmware, and SV installed it. All good! ;D
Cheers,
Ackselle