Several Issues

[lsanabria]

Hi I have 2 Skyviews on my lightsport. I notice that my auto pilot quit working. I don't think it"sees" the servos. This happened right after an update. Also, I've noticed Ed that the ADSB intermittently quits and the screen displays "TIS OK" then back to "ADSB OK" and I can see traffic again. It's a pain when visiting busy airports. Any suggestions?
Thanks in advance.
Louie

 

[skysailor]

Both issues are addressed from Setup. Look in Skyview Network to see if the servos are listed. Bear in mind the servos must be powered (verify any separate CB is in or fuse is good if your system contains these) to be seen. Both servos should be shown and show Online. If not, let us know what you see there.

You may wish to go into the transponder setup and disable TIS traffic. The system prioritizes TIS over ADSB which can lead to the traffic dropouts you have seen. Once TIS is disabled ADSB traffic will be shown whenever the system sees an ADSB tower.

 

[lsanabria]

Will it be safe to leave TIS off? It's on on my other lightsports. Just want to be safe up there.

 

[swatson999]

Will it be safe to leave TIS off? It's on on my other lightsports. Just want to be safe up there.

Whatever did we do to keep safe before ADS-B?

Oh, yeah...we used our eyes and *looked outside*.

You'll be fine...just do what you should be doing already...scanning for traffic with your Mark I Eyeballs.

 

[lsanabria]

Lol, thanks! This made me laugh so hard. Thanks again!

 

[lsanabria]

Got the AP back up and no issues with the ADSB. Thank you again!!