Skyview Installation Guides

[pacecapt]

Is there somewhere on the Dynon site to download a copy of the older Skyview Installation Guides? Reason, my Dynon System has the EMS 220 and all the new guides refer to the EMS 221. l have a non-CANBUS UL Power engine with EMS 220 and the installation and configuration section of the online guide refers to the "with CAN Bus" table. Unless they are identical? Also some QC needs to done as Table 48 for the UL Power Engine makes reference to parts that are used on a ROTAX (Pin 15)...

 

[Stevec]

The current installation guide AO refers to both the EMS220 / 221.

 

[Rhino]

Although the section for the UL Power with CAN Bus on page 7-36 says "Table 48 below", it's a misprint. The table below is Table 51, and the table is properly labeled as such. Table 48 on page 7-31 is for the Rotax 912 ULS.

The Honeywell and Rotax oil pressure sensors are functionally identical, and the Rotax brand is not limited to use on Rotax engines. That's why they're listed in that table. The Honeywell sensor is reportedly no longer available. Settings are discussed here:

Rotax oil pressure pn 456180 definition wrong?

Hi Everyone I have the newer Oil Pressure sensor installed, PN 456180 in a new aircraft built mid 2015 with a 912ULS. I noticed the ems sensor chosen on the skyview system was "ROTAX OIL PRESSURE (HONEYWELL) not "ROTAX OIL PRESSURE (P/N 456180)" On inspection of the latest sensor file...

forum.flydynon.com

There's also a long running thread on the characteristics of the sensor here:

Oil Pressure Sender - Rotax P/N 456-180

ROTALK is a web based support system which provides a common access point for locating key Information - Education - Support for their Rotax Aircraft Engines such as the Rotax 912, Rotax 914, Rotax 912 iS, Rotax 915 iS, Rotax 503 and Rotax 582.

www.rotax-owner.com

However, those tables are labeled as "Suggested." If you look at Table 28, Dynon recommends Kavlico sensors for the UL Power without CAN Bus.