Skyview Network Connection Fault

[N42AH]

Gentlemen,

I recently bought a new to me RV10 with a single display Skyview system.
I am getting the following error:
Skyview Network connection fault - Data 2 pair (Pins 4 & 8)
The same error message is showing up for the following devices:
SV-ARINC-429
SV-AP-Panel
SV-Knob-panel

As a person totally unfamiliar with Skyview and not having a network test cable, I need your direction and hand holding on where to start this venture down the rabbit hole.
Because it is the same error for 3 devices my thinking is that it might be a single location that is causing the the multiple errors.

 

[dynonsupport]

Suggest you download and have available for reference SkyView System Installation Guide, Revision W. See the discussion of this issue SkyView Reports STANDBY NETWORK ERROR beginning on Page 21-11.

Because the SV-AP-PANEL and SV-KNOB-PANEL have 2 SkyView Network connectors, likely there is a daisy chain connection such as:
SV display <---> SV-KNOB-PANEL <---> SV-AP-PANEL <---> SV-ARINC-429.

Please contact Dynon Avionics Sales to obtain a replacement SV-NET-TEST cable; when you obtain that, swap that out for each SkyView Network cable in the chain of those devices until the error disappears.

Gentlemen,

I recently bought a new to me RV10 with a single display Skyview system.
I am getting the following error:
Skyview Network connection fault - Data 2 pair (Pins 4 & 8)
The same error message is showing up for the following devices:
SV-ARINC-429
SV-AP-Panel
SV-Knob-panel

As a person totally unfamiliar with Skyview and not having a network test cable, I need your direction and hand holding on where to start this venture down the rabbit hole.
Because it is the same error for 3 devices my thinking is that it might be a single location that is causing the the multiple errors.