Software Version 12.2 Dynon ADSB in issue

[dsaucier]

I went for a flight this morning using SV software version 12 and my Dynon ADS-B IN worked fine.  After landing, I loaded software 12.2 and now the system is sending a Caution saying that my "ADS-B IN OFFLINE".  I did three full reboots of the entire system which didn't fix anything.  I also went into the setup menu to the ADS-B Status menu and the status is showing "Not Found"  The only thing I did was upload the most recent SV software 12.2.  Any way to resolve this?

 

[jabarr]

Check that the serial port is still configured correctly for your ADSB box. Also you must have satellite reception before the msg will disappear now --- new with 12.2.

 

[dsaucier]

Jabari, thanks much, I'll try both suggestions.

 

[Strahler13]

I had the same problem. Jabarr has your answer.

 

[dynonsupport]

jabarr is correct - in v12.2 you will see a message "ADSB offline" when you don't have GPS reception. This will be corrected in a future firmware update.

I went for a flight this morning using SV software version 12 and my Dynon ADS-B IN worked fine.  After landing, I loaded software 12.2 and now the system is sending a Caution saying that my "ADS-B IN OFFLINE".  I did three full reboots of the entire system which didn't fix anything.  I also went into the setup menu to the ADS-B Status menu and the status is showing "Not Found"  The only thing I did was upload the most recent SV software 12.2.  Any way to resolve this?