SV-32 AP Servos not detected

[jaybhansen@gmail]

I have checked for the correct wiring a whole bunch of times and they seem to be correct, but Skyview is not finding them.  Do you have a way that I can bench test the servos to see if it is in the servos themselves?

 

[Raymo]

When I had an issue with my roll servo, I made a short cable to allow connection directly to the network, ground and power, which proved the servo was not working. Dynon repaired it under warranty (before I was flying).

With both servos having the same problem, it is unlikely that they both failed but is possible.

Have you confirmed 12 volts on the existing connection to each servo?