SV-XPNDR-261 and IFD440 Settings

[timfwalsh01]

Folks,

In my HDX Skyview/SV-XPNDR-261 panel, I just replaced my GNS-430W with a new IFD440.

The plane is outside the hanagar and locked on to a waypoint. ARINC data is showing up on HSI.

In the XPNDR-261 SETUP page, I did set it to GPS DATA "AVIDYNE IFD540/IFD44" GPS DATA OFFLINE

The real question - what is the correct RS232 Config Setting? Previously the GNS-430W was set to "ADSB OUT +"

I called AVIDYNE and he was not sure. they are several options.

Assistance is greatly appreicated!! Thanks, Tim

 

[kurtfly]

I changed my GNS430 to an IFD540. The serial to the transponder is still set to ADSB OUT +. Same as the GNS.

kurt

 

[timfwalsh01]

Kurt,

Thanks for the response.

I did speak to Dynon Tech yesterday afternoon. He told me to use "ADS-B (Avi)"

I went out this morning - and "ADS-B (Avi) worked!!

Oddly, I do not have the option in my IFD440 for "ADSB OUT +"

I do have a IFD540, but did not check if it had "ADSB OUT +"

Again - Thanks!! Tim