Tach and k factor setting adjustments???

[rickw]

EMS settings.

I have done most of the skyview tweaking and have done my first engine start. I have two settings left to adjust and cannot find the appropriate screen/fields.
I need to adjust my red cube fuel flow meter to the k factor 68000 AND
I need to adjust the pin 32 and pin 35 for rpm (one lightspeed, one mag) to adjust the pulses as they appear to be registering high on the tach (show approx 300rpm faster than its running)
I have been through all the menus and wizards and cant see where I can adjust these. Help please....

 

[rickw]

Hello.......

Anybody............................................... :-[

 

[dabear]

Rickw,

for setting up pulses/gallon use Sensor Setup Menu (SETUP Menu > EMS Setup > Sensor Setup. Set both values the same. (pg 7-31 of guide Rev G

For the RPM information check out pg 7-26-27 Rev G (3.0) as it talks about using a higher resistor if you are seeing higher RPM than expected. I didn't have a problem with my setup.

Let me know if this helps.