Trigger coil connecting ROTAX 914

[aerovolga]

Dynon,
Does the connecting of trigger coil for ROTAX 914 is same as for ROTAX 912, and if it's true, I must connect either of two wires to ground and the other one to Dynon d180 through 30kOhm resistor and it doesn't matter which of them, am I right or there is some features for 914?

 

[Dynon]

The 914 has a tach output on its turbo control unit that is designed to drive tachometers. It works fine SkyView's low voltage RPM inputs, but may not have enough voltage for the D180 to pick up reliably. I can't find any positive or negative reports with the D10/D100 series. So you coul dtry that to start. But if the 914 also has a 5th trigger coil like the 912 does, you could likely use that too like you would on a 912.