V. 3.3 Audio Volume

[jauchin]

I just installed ver. 3.3 in my Flight Design CTLS.  The audio is hooked up through a PS-Engineering PM3000 stereo intercom.  I find that the volume of alerts coming from the Skyview, while audible, is too low.  I went into the setup menu and confirmed that volume was set to 100%.  The test sound (the "Dynon Skyview" bootup announcement) is soft, even with no other noise in the cockpit, and is definitely getting hard to hear when the engine is running.  I'm concerned that alerts that I would really want to hear (such as traffic alerts or stall warnings) might not get my attention.   Any suggestions?  The volume knob on the PM3000 intercom unfortunately only sets volume for the intercom system, and apparently does not affect the volume of radios or other attached sources.

 

[dynonsupport]

Audio from SkyView to a PS3000 should work fine. Have you talked to other Flight Design pilots to see if they have the same issue? We just don't know how FD did the wiring between the SkyView and PS3000.

 

[jauchin]

Thanks. I will try posting this question on one of the Flight Design forums. If I get a solution, I will post it here too.