Verns Auto Trim with Dual Displays

[sshae]

Not sure if this is a question for Vern, Dynon, or both..

I am installing Verns M-PWR-2AT controller for auto trim.  His documentation indicates connecting a serial port TX wire to pin 14 of his controller.

I have 2 displays, so my question is do I use a single wire from one of the displays, or should I connect the two TX wires in parallel and then to pin 14 as Dynon would indicate for most of its own accessories?

Thanks - Steve

 

[dynonsupport]

You must connect both displays.

 

[vlittle]

Hi Steve, I sent you an email. Also, Dynon's advice on this is correct, just hook it up with paralleled serial outputs.

Cheers, Vern