N125YX
New Member
Back in May I got the right servos in hand to use a modified arm (longer than the long arm Dynon supplies, so I went to an sV-42 servo). Now that I've finally gotten the arm manufactured I can't figure out how to get the original arm off the servo and I fear that I've screwed the pooch. Once I removed the 310 nut on the shaft I thought the arm would come off, but no joy, so I thought that the 7/64ths allen head locator was the key, and now realize that it was a shear pin. A sheared pin in this case.
A. Do I need to drive out the pinch pin in the boss behind the arm to get this assembly apart?
B. What is holding the arm to the boss?
C. Can I get a replacement shear pin from Dynon with idiot instructions.
A. Do I need to drive out the pinch pin in the boss behind the arm to get this assembly apart?
B. What is holding the arm to the boss?
C. Can I get a replacement shear pin from Dynon with idiot instructions.