EchoCharlie1
New Member
The Skyview installation manual appears to assume a 2-wire (+/-) setup for the digital tach transducer, but the Westach 303DH2T Hall Affect transducer requires a 5-12V input, sensor (+) and ground (-). I've used pin-1 of the EMS-37-pin connector since that is where 12V is coming into the system, used pin-32 for the sensor wire (+) and common ground (-) for the grnd wire. No RPMs.
Additionally, with 12V supplied to pin-1 of the EMS connector, I get no voltage readings on the Skyview, yet all systems are up and running.
Last problem, with oil pressure reading 57 psi with engine off and over 160psi with engine running, I am assuming that the Westach 387-100KV is not supported, along with the fuel pressure transducer, Westach 387-30KV.
Thank you for your assistance.
R/
Frank
Additionally, with 12V supplied to pin-1 of the EMS connector, I get no voltage readings on the Skyview, yet all systems are up and running.
Last problem, with oil pressure reading 57 psi with engine off and over 160psi with engine running, I am assuming that the Westach 387-100KV is not supported, along with the fuel pressure transducer, Westach 387-30KV.
Thank you for your assistance.
R/
Frank