Which X-Amps breakers for all your products

[mcr01passion]

Hi,
I've got a D100 and a HS34 on my desk, ready to install. I will order an AP74 and two SV32.
I only found on your installation manuals that I need a 3-Amps Breaker for my D100, but nothing about the others.

May you tell me, and for everybody reading this forum, which X-Amps breakers do we have to use for all your products (EFIS, EMS, AP servos, HS34, AP 74, and others...)?

Thank you!

MCR 01 Passion (France)
Dyn'Aero MCR 01 Sporster (VLA) also known as Lafayette

 

[dynonsupport]

Current draw of each of our instruments and products is in each installation manual, under the electrical installation section of each.

Remember that the main purpose of fuses/breakers is to protect WIRING, not the devices. In short, you need to size your wire to be able to carry the load specified, and then use a breaker/fuse that can accommodate the maximum load, plus some extra, but not more than the wire can handle before burning up. Chapter 11 of this FAA advisory circular is instructive.

 

[mcr01passion]

Ok, I checked everything like you said, and I choosed 3-Amps breakers for the your products I have or will have.

Thank You.